
drying out waders
- mississippi_duc_htr
- Veteran
- Posts: 673
- Joined: Mon Dec 10, 2001 1:01 am
- Location: On the wrong damn side of the state for sure for duck hunting!!!!, HATLEY,MS
drying out waders
Well I finally fell in first time in 10 years. Went back too get the boat to move to a new location about 7:00. I had already walked through the spot and stepped over a log in the water, dont know what happen but hit the log got over balanced and went in up too my neck. Man was that an eye opener that early in the morning.Whewwwwwww weeeeeeee!!!!!! Took my breath and all, anyway last time I fell in I was wearing canvas wader and it didnt take long too dry them out. Now have neoprene but havent fell in since I ve had them. This morning the boots are still wet on the inside and they wont seem too dry out laid them in the sun the rest of yesterday and kept them on a heater vent all night and they are still wet. Any ideas on getting them too dry out today so I can hit it again in the morning. We still kept on hunting till 10:00 but was I freezing my axx off. Worst part was didnt fire a shot, and saw very few ducks 

"You can either shoot on the next pass or watch me do it." Winchester rules hehehehe .......Amen
i like those little plug in the wall boot/wader dryers.....stick em on in the evening, they'll be dry as a bone (or close) next morning....
i don't like the propane ones, even tho i think they dry them quicker.....the lil propane tanks are just one more thing to keep up w/...
cost about 30 bucks and you can get them at most any hunting store....i know van's has em and i'm sure MM does too....gator
i don't like the propane ones, even tho i think they dry them quicker.....the lil propane tanks are just one more thing to keep up w/...
cost about 30 bucks and you can get them at most any hunting store....i know van's has em and i'm sure MM does too....gator
HRCH Eight Gauge - Gauge (see you on the bridge buddy)
HRCH Eight Gauge's Mountain Man - Trapper
HRCH Eight Gauge's Mountain Man - Trapper
- Greenhead22
- Duck South Addict
- Posts: 19203
- Joined: Sun Apr 29, 2001 12:01 am
- Location: Mississippi/Louisiana/Arkansas
- Doc & Nash
- Duck South Addict
- Posts: 4859
- Joined: Sun Nov 18, 2001 1:01 am
- Location: Southaven
- Contact:
Put on a couple of pairs of socks and put your feet in the boots, this gets any water out that can possibly be dried out. Then pull the Neo part all the way down to the top of the boot and lay them in front of the refridgerator. )top of boot facing the vent on the bottom of refridge) this will dry them out over night.
Conservation is number one to all true outdoorsmen
Trey Edwards
UH HRCH Nashs' Legend MH RIP 8/11/02- 10/12/12
The yet to be named Chocolate Dawg
Trey Edwards
UH HRCH Nashs' Legend MH RIP 8/11/02- 10/12/12
The yet to be named Chocolate Dawg
Cheap wader dryer. Every bit as effective as the more expensive jobs.
Take a PVC T and put pieces of PVC into the T to match the width of the waders. Then stick elbows on both ends of that and put longer pieces of PVC into the elbows. Then insert the whole contraption into your waders and stick your wife's hair dryer in the open end of the T. One longer PVC end goes into each leg. Turn it on. Takes no time to dry your waders. If the hair dryer doesn't exactly fit the opening, use duct tape.
I had maybe 5 bucks in parts and we already had the hair dryer. Boy was my wife pizzed when she came home and found her hair dryer in the garage drying my waders.

Take a PVC T and put pieces of PVC into the T to match the width of the waders. Then stick elbows on both ends of that and put longer pieces of PVC into the elbows. Then insert the whole contraption into your waders and stick your wife's hair dryer in the open end of the T. One longer PVC end goes into each leg. Turn it on. Takes no time to dry your waders. If the hair dryer doesn't exactly fit the opening, use duct tape.
I had maybe 5 bucks in parts and we already had the hair dryer. Boy was my wife pizzed when she came home and found her hair dryer in the garage drying my waders.


Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote. Benjamin Franklin.
Those who can do. Those who can't get on MSDUCKS and try to convince everyone they can.
Those who can do. Those who can't get on MSDUCKS and try to convince everyone they can.
- rebelduckaholic
- Duck South Addict
- Posts: 3222
- Joined: Thu Jan 10, 2002 1:01 am
- Location: Oxford
- mississippi_duc_htr
- Veteran
- Posts: 673
- Joined: Mon Dec 10, 2001 1:01 am
- Location: On the wrong damn side of the state for sure for duck hunting!!!!, HATLEY,MS
thanks!
Thanks for all the suggestions been awhile since I had wet feet hope it'll be along time before it happens again 

"You can either shoot on the next pass or watch me do it." Winchester rules hehehehe .......Amen
The PVC suggestion works-only don't use a hair dryer. Use a small ceramic electric heater from wal mart, etc. You can drill holes in the pipe to help dry all the way up. However now know that the HARD part is drying the boot part.
I got some good ideas from some of the posts. Been there been wet, wet, and longer wet. Certainly will be again.
I got some good ideas from some of the posts. Been there been wet, wet, and longer wet. Certainly will be again.
- sipseyduck
- Regular
- Posts: 54
- Joined: Sat Nov 22, 2003 9:52 am
- Contact:
rebelduckaholic wrote:It might work just as good. But 5 dollars and pissing the wife off vs 30 peet boot dryer. I will stick with the store bought one
I'm into my 16th year of blissful matrimony. Part of the secret to the success is knowing when I can get away with chit like that and when I can't.


Kinda like my new shotgun I got a few weeks ago. It's all in the timing boyz. Everything else is easy.
Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote. Benjamin Franklin.
Those who can do. Those who can't get on MSDUCKS and try to convince everyone they can.
Those who can do. Those who can't get on MSDUCKS and try to convince everyone they can.
Go to your local muffler shop, and ask them to build you one. Take the muffler pipe and make a base in the form of an "H" with the center of the "H" being about 18 inches. The other two pieces need to be about 16 inches. Then squeeze the ends down on the 18' inch of pipe and weld them to the center of the other two pieces. Next cut a hole for a insert pipe into the top of the 18" center piece ... Oh heck, just call Billy Ryals at 662-226-5177 and get him to make you one for waders. Works off of a hair dryer and will dry a completly soaked set of felt lined waders before your next morning hunt. You will never regret it 

-
- Duck South Addict
- Posts: 3488
- Joined: Thu Dec 05, 2002 7:23 am
- Location: Tunica or Olive Branch
Doc & Nash wrote:Put on a couple of pairs of socks and put your feet in the boots, this gets any water out that can possibly be dried out. Then pull the Neo part all the way down to the top of the boot and lay them in front of the refridgerator. )top of boot facing the vent on the bottom of refridge) this will dry them out over night.
How'd you learn that trick you been stepping out of the boat without your handy stick depth finder?
Who is online
Users browsing this forum: Ahrefs [Bot], Amazon [Bot], Bing [Bot] and 9 guests